|
|
|
|
|
|
INSTRUCTIONS
|
- Hang hoods, adjusting tension on hanging rods to position hoods so
they fit flush with each other (see figure 5).
- Bolt the tops of the hoods together by sliding a threaded rod
through the mounting angle slots and holes and fastening it into
position by using nuts and washers as shown in figure 2.
- Install end to end mating clips and back to back mating clips.
Run a bead of caulk along the seam to be covered and slip the mating
clip into position as shown in figures 3 & 4.
- The end product should resemble figure 1.
|
|
Figure 1. End to End or Back to Back Hood Connection Detail
|
|
|
|
|
2. Exploded View of Connecting Angles on Top of Hood
|
|
|
|
|
3. End to End Connecting Hoods: Mating Trim Detail
|
|
|
|
|
4. Back to Back Connecting Hoods: Mating Trim Detail
|
|
